2011 NEW PRODUCTS
Please be sure to read before handling the product. Please refer to "safety instructions", "common safety instructions for products listed in this manual", "common safety instructions for flow controller" from page 24 through 35.
24
Safety Instructions
* Safety Instructions are subject to change without advance notice.
Failure to heed the warning of apparent danger may result in death or serious injuries.
Failure to heed the warning of conditionally dangerous situations may result in death or serious injuries.
Failure to heed the warning of conditionally dangerous situations may result in minor or not too serious injuries or
damage to properties.
This Safety Instructions aim to prevent injuries to human bodies and damage to properties by requiring proper use of PISCO
devices.
Also the relevant requirements of ISO 4414 and JIS B8370 must be observed.
ISO 4414: Pneumatic fluid power … Recomendations for the application of equipment to transmission and control systems.
JIS B 8370: General standards for pneumatic systems
Safety instructions are classified into "Danger", "Warning" and "Caution", depending on the degree of danger or damage involved
when the safety instructions are not complied with in handling the equipment.
Danger
Warning
Caution
Warnings : 1. Make a selection of pneumatic equipment.
(1) Well knowledgeable and experienced persons such as a pneumatic system designer or who is in charge of deciding
specification should select pneumatic equipment.
(2) The applicable conditions of the products in this catalogue are diverse. Therefore, judge the conformity of systems with
required analysis or tests by system designers or persons who is in charge of deciding specifications. The guarantee
of initial performance and safety of the system is on responsibility of the person who decides specifications. Hereafter,
examine all the specification with updated products catalogues and technical documents in order to avoid malfunctions of
equipment, and then develop systems.
2. Handle pneumatic equipment with enough knowledge and experience.
(1) Mishandling of compressed air is dangerous. Conduct assembly, operation and maintenance of devises with pneumatic
equipment by persons with enough knowledge and experience.
3. Do not operate and remove the equipment until safety is confirmed.
(1) Conduct inspection and maintenance of equipment after confirming fail-proof measures of work pieces or runaway-proof
device are properly working.
(2) When removing equipment, make sure that above safety measures are conducted. Then, stop air supply and electric source
of equipment making sure the pressure inside the system is zero before removing equipment.
(3) When re-activate equipment, make sure safety measures against fly-out are taken and re-activate equipment with care.
Disclaimer
1. We take no responsibility whatsoever for any incidental and indirect damages (e.g. manufacturing line stop, business interruption, loss of
profit and physical injury) caused by the use or defect in use of PISCO devices.
2. We take no responsibility whatsoever for the device failure damage caused by natural disaster, fire, except fire responsible to us, act by a
third party and intention or negligence by customers.
3. We take no responsibility whatsoever for the damage caused by uses beyond the range of specification described in our catalogues and
handling instructions.
4. We take no responsibility whatsoever for the damage caused by the re-creation of devices and the failure from the combinations of
software and connected equipment.
5. We pay the damage for the failure caused by PISCO devises up to a ceiling of the purchased Pisco devise expense.