Page 18 of 19
17 Troubleshooting
Noisy operation
Clean the Filters and empty the Dust Canister
Reduced Suction
or
No Suction
Clean the Filters and empty the Dust Canister.
Check for blockages and unblock
The Suction Relief Slide on the hose handle may be
Open. If so, Slide it closed.
The Water Float may be blocking the air intake. Turn off
and let the float drop back down.
If sucking up water, the Dust canister may be full. Switch
off, unplug and empty dust canister.
Over-heating / Stopping
Switch off, unplug then Clean the Filters, empty the Dust
Canister, check for blockages and unblock then allow
vacuum cleaner to cool for approximately 60 minutes.
Floor head hard to push
Due to the strong suction of your vacuum cleaner, it may
be difficult to push, especially over thick carpet. Rather
than force the Floor Brush, lift the Floor Brush
momentarily to allow air to flow into the vacuum
releasing the built up suction pressure, then continue
vacuuming.
Slide open the vacuum suction adjusting plate (Sliding
Block) located on the hose handle grip. This will reduce
suction to the floor head.
Change the floor head attachment to use the attachment
without the brush and squeegee.
