Additional information
09
40
En
Chapter 9:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity disconnect
the power plug from the outlet and insert again to return to normal operating conditions.
Problem
Remedy
The power does not turn on.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the receiver to shut off automatically.
• If the power shuts off automatically, take the unit to your nearest
Pioneer authorized service center or your dealer for servicing.
Power cannot be turned off.
(
ZONE2
ON
is displayed.)
• Press the
ZONE 2 ON/OFF
button to switch the sub zone off.
No sound is output when a
function is selected.
• Check the audio output settings of the source component.
• Make sure the component is connected correctly (refer to
Connecting your equipment
on page 13).
• Press
MUTE
on the remote control to turn muting off.
• Press
SIGNAL SEL
to select the proper input signal (see
Selecting
the audio input signal
on page 25).
• Even if you connect the playback components with an HDMI cable,
no sound will come out of the speaker connected to this receiver. An
audio cable connection is also needed for this.
• If the connection was made using an optical or a coaxial cable,
you'll need to press
SIGNAL SEL
button to select the input signal
corresponding to the playback components (refer to
Selecting the
audio input signal
on page 25).
No image is output when a
function is selected.
• Make sure the component is connected correctly (refer to
Connecting your equipment
on page 13).
• Use the same type of video cables for the source component and
TV to connect to this receiver.
• Check
The Input Assign menu
on page 34 to make sure you’re
assigned the correct input.
• The video input selected on the TV monitor is incorrect. Refer to the
instruction manual supplied with the TV.
VSX-RS320_DWXCN.book 40 ページ ２０１０年４月２日 金曜日 午後５時４６分
