Additional information
11
76
En
There seems to be a time
lag between the speakers
and the output of the
subwoofer.
• See
Automatically setting up for surround sound (MCACC)
on page 29 to
set up your system again using MCACC (this will automatically
compensate for a delay in the subwoofer output).
After using the Auto
MCACC Setup, the speaker
size setting (
LARGE
or
SMALL
) is incorrect.
• Low-frequency noise could have been caused by an air conditioner or
motor. Switch off all appliances in the room and rerun the Auto MCACC
Setup.
Can’t operate the remote
control.
• Replace the batteries (refer to page 7).
• Operate within 7 m, 30
°
of the remote sensor (refer to page 10).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off.
• Press
DIMMER
on the remote control repeatedly to return to the
default.
The
Bluetooth
wireless
technology device cannot
be connected or operated.
Sound from the
Bluetooth
wireless technology device
is not emitted or the sound
is interrupted.
• Check that no object that emits electromagnetic waves in the 2.4 GHz
band (microwave oven, wireless LAN device or
Bluetooth
wireless
technology apparatus) is near the unit. If such an object is near the unit,
set the unit far from it. Or, stop using the object emitting the
electromagnetic waves.
• Check that the
Bluetooth
wireless technology device is not too far from
the unit and that obstructions are not set between the
Bluetooth
wireless
technology device and the unit. Set the
Bluetooth
wireless technology
device and the unit so that the distance between them is less than about
10 m and no obstructions exist between them.
• Check that the
Bluetooth
ADAPTER and the
ADAPTER PORT
of the unit
are correctly connected.
• The
Bluetooth
wireless technology device may not be set to the
communication mode supporting the
Bluetooth
wireless technology.
Check the setting of the
Bluetooth
wireless technology device.
• Check that pairing is correct. The pairing setting was deleted from this
unit or the
Bluetooth
wireless technology device. Reset the pairing.
• Check that the profile is correct. Use a
Bluetooth
wireless technology
device that supports A2DP profile and AVRCP profile.
Problem
Remedy
VSX-820_SYXCN_En.book 76 ページ 2010年4月12日 月曜日 午後6時52分