Additional information
11
75
En
English
Français
Deutsch
Nederlands
Italiano
Español
No sound from surround or
center speakers.
• Connect the speakers properly (refer to page 18).
• Refer to
Speaker Setting
on page 43 to check the speaker settings.
• Refer to
Channel Level
on page 45 to check the speaker levels.
The
PHASE CONTROL
feature doesn’t seem to
have an audible effect.
• If applicable, check that the lowpass filter switch on your subwoofer is
off, or the lowpass cutoff is set to the highest frequency setting. If there is
a
PHASE
setting on your subwoofer, set it to 0º (or depending on the
subwoofer, the setting where you think it has the best overall effect on the
sound).
• Make sure the speaker distance setting is correct for all speakers (see
Speaker Distance
on page 46).
Considerable noise in radio
broadcasts.
• Connect the antenna (page 27) and adjust the position for best
reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall (or connect an outdoor FM antenna).
• Connect an additional internal or external AM antenna (page 27).
• Turn off equipment causing interference or move it away from the
receiver (or move antennas farther away from equipment causing noise).
Broadcast stations cannot
be selected automatically.
• Connect an outdoor antenna (refer to page 27).
Noise during playback of a
cassette deck.
• Move the cassette deck away from your receiver, until the noise
disappears.
Sound is produced from
other components, but not
from LD or DVD player.
• Set the
SIGNAL SEL
to
HDMI
,
C1
/
O1
/
O2
(
DIGITAL
) or
A
(analog)
according to the type of connections made (refer to page 41).
• Set the digital input settings correctly (refer to page 46).
• Make digital connections (refer to page 23) and set the
SIGNAL SEL
to
C1
/
O1
/
O2
(
DIGITAL
) (refer to page 41).
• Refer to the instruction manual supplied with the DVD player.
No sound is output or a
noise is output when
software with DTS is played
back.
• Set the digital volume level of the player to full, or to the neutral
position.
• Make sure the player’s settings are correct and/or the DTS signal out is
on. Refer to the instruction manual supplied with the DVD player.
• Set the input signal type to
C1
/
O1
/
O2
(
DIGITAL
) (see
Choosing the
input signal
on page 41).
During a playback search,
noise is output from a DTS
compatible CD player.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Everything seems to be set
up correctly, but the
playback sound is odd.
• Check that the positive/negative speaker terminals on the receiver are
matched with the corresponding terminals on the speakers (see
Connecting the speakers
on page 18).
Problem
Remedy
VSX-820_SYXCN_En.book 75 ページ ２０１０年４月１２日 月曜日 午後６時５２分
