Downloaded from www.vandenborre.be
Additional information
10
52
En
Broadcast stations cannot
be selected automatically.
• Connect an outdoor antenna (refer to page 25).
No sound from surround or
center speakers.
• Connect the speakers properly (refer to page 18).
• Refer to
Speaker setting
on page 40 to check the speaker settings.
• Refer to
Channel level
on page 41 to check the speaker levels.
No sound from subwoofer.
• Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have an
LFE channel.
• Switch the subwoofer setting in
Speaker setting
on page 40 to
YES
or
PLUS
.
• Switch the
LFEATT (LFE Attenuate)
on page 36 to
LFEATT 0
or
LFEATT 5
.
The
PHASE CONTROL
feature doesn’t seem to
have an audible effect.
• If applicable, check that the lowpass filter switch on your subwoofer is
off, or the lowpass cutoff is set to the highest frequency setting. If there is
a
PHASE
setting on your subwoofer, set it to 0º (or depending on the
subwoofer, the setting where you think it has the best overall effect on the
sound).
• Make sure the speaker distance setting is correct for all speakers (see
Speaker distance
on page 41).
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
No sound is output or a
noise is output when
software with DTS is played
back.
• Set the digital volume level of the player to full, or to the neutral
position.
• Make sure the player’s settings are correct and/or the DTS signal out is
on. Refer to the instruction manual supplied with the DVD player.
• Set the input signal type to
C1
/
O1
/
O2
(
DIGITAL
) (see
Choosing the
input signal
on page 38).
During a playback search,
noise is output from a DTS
compatible CD player.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Everything seems to be set
up correctly, but the
playback sound is odd.
• Check that the positive/negative speaker terminals on the receiver are
matched with the corresponding terminals on the speakers (see
Connecting the speakers
on page 18).
Can’t operate the remote
control.
• Replace the batteries (refer to page 10).
• Operate within 7 m, 30
°
of the remote sensor on the front panel (refer to
page 7).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off.
• Press
DIMMER
on the remote control repeatedly to return to the
default.
Problem
Remedy
VSX-520_SYXCN_En.book 52 ページ ２０１０年４月１２日 月曜日 午後７時１３分
