Advanced Setup
EXPER
T
81
En
Assigning the Component Video Inputs
If you used component video cords (and only if you did so) to connect any equipment you must tell the
amplifier which device is hooked up with this special kind of cable. If you did not use component video
cord (which is a specialized cord that separates the video signal into two color spectrums and a light
spectrum for transmission) then you don't need to worry about the procedure below. The default settings
for the component video inputs are as follows: 1= off; 2= off; 3= off.
1
Turn on the amplifier and your TV,
press the AMP on the remote
control.
2
Press the SUB button on the remote
control.
3
Press the SYSTEM SETUP button.
4
Looking at the on-screen display on
your TV, use the
5∞
buttons to
select INPUT ASSIGN. Press the
ENTER button.
5
Use the
5∞
buttons to select
C'NENT VIDEO IN. Press the ENTER
button.
6
Use the
5∞
buttons to move
through the different component
video input settings and use the
2
3
buttons to select the component
that you hooked up to that
component video in.
If you're not sure which component is connected to
which component video in, look on the back of the
amplifier and check the cables you connected.
7
When you're finished use the
5∞
buttons to select RETURN and press
ENTER.
You will leave the "Assigning the Component Video
Inputs" mode.
8
Use the
5∞
buttons to select
RETURN and press ENTER, again.
Then, use the
5∞
buttons to select
EXIT and press ENTER.
STATUS
SPEAKER
A/B
LOUDNESS
INPUT
ATT.
Amplifier
MAIN
SUB
SIGNAL
SELECT
TAPE 2
MONITOR
SYSTEM
SETUP
DISPLAY
DIMMER
VIDEO
SELECT
EFFECT/
CH SEL.
BASS/
ATREBLE
TONE
AMP
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
REMOTE
SETUP
CD-R/
TAPE1
CD
TUNER
VIDEO
SAT
TV
CONTROL
1
2
3
4
5
1.Input Assign
[ 1.Digital-In Select ]
[
2.C'nent Video
In
]
[Return]
1.2. C' nent Video In
C' nent-In1
[
DVD/LD
]
C' nent-In2
[ OFF ]
C' nent-In3
[ OFF ]
[Return]
6
memo
System Setup
[
Auto Surround Setup
]
[
1. Input Assign
]
[2. Surround Setup]
[3. Expert Setup]
[4. THX Audio Setup]
[Exit]
1.2. C' nent Video In
C' nent-In1
[ DVD/LD ]
C' nent-In2
[
VCR1
]
C' nent-In3
[ OFF ]
[Return]
7
If you connect the TV monitor with compo-
nent video cord, and the DVD player with
composite or S video cord then you should
set that terminal to off.
