SX-SW77
41
5
6
7
8
5
6
7
8
C
D
F
A
B
E
7. GENERAL INFORMATION
7.1 DIAGNOSIS
7.1.1 TEST MODE
1. Conditions During Test Mode
• During Test mode, the unit will not be shut down for an emergency even if one of the failures mentioned below occurs.
• After the unit has been shut down in Normal mode for an emergency upon detection of one of the failures mentioned below,
you can turn it on immediately, without waiting for one minute, in Test mode.
2. How to enter Test mode
• During Standby mode, hold the AUDIO INPUT and STANDBY/ON keys on the Display unit pressed for 3 seconds.
• Test mode can also be entered in either of the following ways:
1. Turn on the power with the STEST port (microcomputer terminal IC5501: 43-pin) at High (5 V).
(See "Test mode connecting point".)
2. Turn on the power while holding both the AUDIO INPUT and STANDBY/ON keys on the Display unit pressed.
Note:
If the power cord was disconnected immediately before, be sure to wait at least one minute before turning on the
power in the manner mentioned above. Otherwise, the unit may not operate properly.
3. How to quit Test mode, and conditions for quitting
• To quit Test mode, turn the power off to turn the power off.
• When Test mode is quit, only data on failure in RAM will be initialized, and data on user settings in RAM will not be
initialized.
4. Indications on the FL display when Test mode is entered
• The function setting will be DVD/DVR1.
• The indication on the FL display when Test mode is entered will differ depending on whether the unit was shut down
normally or with an abnormality detected, as shown below:
• ADV mode will become 5-channel STEREO so that multichannel output can be obtained.
5. Operations during Test Mode
• Basically, operations in Test mode are the same as in Normal mode. However, to indicate that the unit is in Test mode,
the following are displayed when the functions are changed:
[After a normal power-off]
[After a shutdown caused by an EEPROM failure]
FL display
FL display
FL display
FL display
FL display
FL display
FL display
FL display
FL display
[After a shutdown caused by high-temperature detection]
FL display
FL display
FL display
[After a shutdown caused by over current detection]
[Functions]
[FL display]
• North America
• Excepting North America
P O W E R
O N
V O L
0
V 1
D
V
S E R
E E P
E R R
V O L
0
V 1
D
V
S E R
V O L
0
V 1
D
V
S E R
O V E R
P
T E M
V O L
0
V 1
D
V
S E R
O C
E
R
R R O
V 1
S E R
DVD/DVR1
I G
S E R
DIGITAL
N A
S E R
ANALOG
T X
S E R
FM/AM
V
V
V
V
D
V 2
S E R
DVD/DVR2
V
D
D
A
[Functions]
[FL display]
V D
S E R
DVD
C
S E R
PC/GAME
U X
S E R
AUX
T X
S E R
TUNER
V
V
V
V
D
T V
S E R
DTV
V
D
P
A
