Pioneer SPH-EVO93DAB, Installation Manual

Page: 9 / 64

9
En
En
gl
is
h
used, the reception sensitivity will be
poor.
• Do not cut the accessory metal sheet.
This would reduce the sensitivity of the
GPS aerial.
• Take care not to pull the aerial lead when
removing the GPS aerial. The lead may
become detached.
• Do not paint the GPS aerial, as this may
affect its performance.
WARNING
Do not install the GPS aerial over any sensors or vents on the dashboard of the vehicle, as
doing so may interfere with the proper functioning of such sensors or vents and may
compromise the ability of the metal sheet under the GPS aerial to properly and securely
affix to the dashboard.
GPS aerial
Metal sheet
Peel off the protective sheet on the rear.
Double-sided tape
Clamps
Use clamps to secure the lead where necessary inside the vehicle.
NOTES
• Affix the metal sheet on the surface as level as possible where the GPS aerial faces the
window.
• Affix the GPS aerial on the metal sheet using the double-sided tape.
• The metal sheet contains a strong adhesive which may leave a mark on the surface if it is
removed.
• When attaching the metal sheet, do not cut it into small pieces.
• Some models use window glass that does not allow signals from GPS satellites to pass
through. On such models, install the GPS aerial on the outside of the vehicle.
When installing the aerial inside the vehicle (on the dashboard or rear
shelf)
Make sure the surface is free of
moisture, dust, grime, oil, etc.,
before affixing the metal sheet.