57
EN
T
roubleshooting
Replacing the Rubber Gaskets
This section describes how to replace the rubber gaskets inside the transmitters of the sensors.
1
Remove the sensor’s transmitter’s cover.
See “Checking Operation of the Sensors” (page 8).
2
Gently pinch the gasket with the tweezers and lift up to remove it.
Left side
Right side
Be careful to not scratch the gasket groove or the area around it.
•
3
Remove any dirt or materials in the area around the gasket groove.
Left side
Right side
4
Check that the new rubber gasket has no tears or twists, and that there is no dust or other foreign
material stuck to it.
5
Align the rubber gaskets with the points enclosed by the dotted line to insert it.
Left side
Right side
Use your finger to press in the gasket. There is a risk of damaging the gasket if you use the tweezers.
•
Be careful that you do not damage the gasket with your fingernails.
6
Confirm that the entire length is completely inserted and then install the cover of the sensor’s
transmitter.
See “Checking Operation of the Sensors” (page 8).
