Additional information
11
65
En
English
Problem
Considerable noise in radio
broadcasts.
Auto tuning does not pick up
some stations.
Sound is mono only.
Remedy
• Tune into the correct frequency.
• Connect the antenna (refer to the Setup Guide).
• Fully extend the FM wire antenna, position for best reception,
and secure to a wall.
• Connect an outdoor FM antenna (page 61).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer
to the Setup Guide, page 61).
• Turn off any other equipment that may be causing the noise or
move it away from the unit.
• The tuning interval is incorrect for your country or region. Try
switching the tuning interval (frequency step) (page 57).
• The radio signal is weak. Auto tuning will only detect radio
stations with a good signal. For more sensitive tuning, connect
an outdoor antenna.
• Check that the tuner is not set to FM mono (page 35).
Tuner
Message
CHILD LOCK
CAN’T USE
96K STEREO
or
96KHZ STEREO
(OSD only)
Desciption
• This message appears when the front panel buttons are
pressed when the child lock feature is active. See Child Lock on
page 58 for more on switching on/off the child lock.
• This message appears when it is not possible to output the test
tone. Make sure the system is not muted, the headphones are
not plugged in, and neither the
AUTO
or
STEREO
Surround
mode is selected to output the test tone. See also
Setting the
relative volume level of each channel
on page 41.
• This message appears when you try to use the bass mode
when the headphones are connected.
• This message appears when the source sampling rate is 96kHz
and you try to choose a Surround/Advanced Surround listening
mode or try to adjust the bass or treble.
Error Messages
