Pioneer ]S-2EX, Operating Instructions Manual

Page: 5 / 25

5
En
English
Attaching and removing the front grille
The front grille of this speaker system is removable. Follow
the instructions below to attach/remove the grilles.
Attaching the grille
1 Insert the supplied fastening screws into the four
holes provided on the front of the speaker.
Use your fingers (not a screwdriver) to secure the screws to
the front of the speaker.
2 Line up the holes on the grille with the protruding
ends of the screws on the front of the speaker and press
firmly.
3 Insert the supplied finishing screws into the four
holes on the front of the grille and tighten to secure.
Use your fingers to tighten the finishing screws.
Removing the grille
1 Loosen, then remove the finishing screws from the
four corners on the front of the grille.
2 After detaching the grille, remove the fastening
screws from the four holes on the front of the speaker.
Optionally, you can insert the supplied caps into the holes.
• Do not use a screwdriver (or hex wrench) to tighten the
screws. Overtightening could damage the speaker.
• When not in use, store the screws with these operating
instructions for safekeeping.
Magnetic shielding
This speaker system is magnetically shielded. However,
depending on the installation location, color distortion may
occur if the speaker system is installed extremely close to the
screen of a television set.
If this happens, turn off the television, then turn it on again
after 15 min to 30 min. If the problem persists, place the
speaker system away from the television set.
Cleaning the speaker cabinet
With normal use, wiping with a dry cloth should be sufficient
to keep the cabinet clean. If necessary, clean with a cloth
dipped in a neutral cleanser diluted five or six times with
water, and wrung out well. Do not use furniture wax or
cleansers.
Never use thinners, benzine, insecticide sprays or other
chemicals on or near this unit since these will corrode the
surfaces.
Finishing
screws
Long fastening
screws
Short fastening
screws