41
Figure 17 – Condensate Line Detail
NOTES:
1. Condensate line must be pitched at least 1/4" per foot to properly drain. If this cannot be done, or a very long length
of condensate hose is used, you must increase the condensate line to a minimum of 1” ID and place a tee in the line
after the condensate neutralizer to properly reduce vacuum lock in the drain line.
2. Plastic pipe should be the only material used for the condensate line. Steel, brass, copper, or other materials will be
subject to corrosion or deterioration.
3. It is also very important that the condensate line is not exposed to freezing temperatures or any other type of
blockage.
PART 8 – FIELD WIRING
ELECTRICAL SHOCK HAZARD –
For your safety, turn off electrical power supply at service entrance
panel before making any electrical connections to avoid possible electric shock hazard. Failure to do so
can cause severe personal injury or death.
Wiring must be N.E.C. Class 1.
If original wiring supplied with the heater must be replaced, use only TEW 105
o
C wire or equivalent.
Heater must be electrically grounded as required by National Electrical Code ANSI/NFPA 70 – Latest
Edition.
A. INSTALLATION MUST COMPLY WITH:
1. National Electrical Code and any other national, state, provincial, or local codes or regulations.
2. In Canada, CSA C22.1 Canadian Electrical Code Part 1, and any local codes.
B. FIELD WIRING
All connections made to the heater in the field are done on the field connection board located in the
cabinet on the top left area of the unit. Multiple knockout locations are available to route field wires into
and out of the cabinet.
Summary of Contents for PHR100-55
