Pioneer PDP 502MX, Manual

Page: 70 / 143

70
Tiltable Plasma Display Wall-Mount Hardware: PDK-5006
4) Adjusting the angle
This mounting can be tilted 25 degrees, without set increments.
The work should be done by two people.
1
Loosen screw
c
on the left and right vertical frames.
2
While sliding the arm down, push the display to the desired angle.
3
Once the desired angle is reached, tighten screw
c
on the left and right frames.
When mounting the display flush or parallel to the wall,
secure the movable and fixed portions of the mount frame
by tightening the screws
a
, as shown. This prevents
accidental tilting of the display. You must also tighten the
left and right
c
screws.
c
a
After mounting the unit at an angle, an additional
reinforcement measure can be taken by attaching an
appropriate wire and a flat bar using screws
a
.
When the angle is set to less than 5°, please secure using
wires or a flat bar etc.
Measuring the opening distance X enables approximate
angle values to be determined.
X Angle
181 mm 5°
236 mm 10°
290 mm 15°
341 mm 20°
Wire, flat bar
X