12
EN
English
Installation and Connections
Connection to INPUT1 and INPUT5
Various components can be connected to the INPUT1 and
INPUT5 jacks. After connections are made, on-screen
setup is necessary to match the characteristics of the
connected component. Please see pages 21 to 23 for on-
screen setup after connection.
Note
When making connections to INPUT1, please refer to appendix 3
on page 49.
INPUT5 terminal
Output source
[ON SYNC]
Y
C
B
/P
B
C
R
/P
R
Video component with
RGB output
G ON SYNC
R
B
Y
C
B
/P
B
C
R
/P
R
Video component with
component video output
About the Input Connectors on this
Unit
Consult the following chart when making connections to
a plasma display (pages 13 to 19).
*1 Although INPUT1/INPUT5 are compatible with various kinds
of signals, setup using the on-screen menu is necessary after
connections are made in order match the characteristics of
the source component (pages 21 to 23).
*2 INPUT1 is compatible with Microsoft’s Plug & Play (VESA
DDC 1/2B).
*3 Depending on the video output board of the computer, this
type of connection may not be possible.
*4 Although INPUT2 is compatible with various kinds of signals,
setup using the on-screen menu is necessary after
connections are made in order match the characteristics of
the source component (pages 23 to 24).
INPUT
4
INPUT
3
*3
*3
Input Connector INPUT
1
*1
INPUT
2
*4
Analog RGB
Component video
S-video
Composite video
Digital video
P
ersonal
computer
(PC)
AV
component
Connected
component and signals
Analog RGB
S-video
Composite video
*2
INPUT
5
*1
For the screen sizes and input signals that INPUT1
and INPUT5 are compatible with, please refer
to appendix 1 (page 46) and appendix 2 (pages 47
to 48).
Installation and Connections
CAUTION
÷
Handles should not be removed or reattached by anyone other
than the professional installation technician or service
personnel.
÷
If handles must be removed due to specific installation
conditions, the mounting screws should be stored carefully
together with the handles. To ensure safety, the mounting
screws should be tightened to a minimum torque of 2N·m (20
kgf·cm) when reattaching the handles.
÷
When moving the display, it should always be carried by two
persons holding the rear handles in the manner shown.
NO!
÷
Never attempt to move the plasma display by holding only one
of the handles.
÷
When installing the plasma display, do not use the handles as
means of hanging the display; also do not use them as devices
to prevent tipping over (see illustration).
