Pioneer PD-70AE, Instruction Manual

Page: 10 / 144

10
> Before Start > Part Names > Install > Playback
Advanced Setup | Others
The control jack
If you have multiple Pioneer brand devices, and if they have
CONTROL IN/OUT jacks, you can centrally control them
through the remote controller sensor on the amplifier, for
example. By connecting with monaural miniplug cables
(without resistors) as shown in the diagram, then even if this
unit and other devices are put in locations where they
cannot receive the remote controller signal, you can still use
the remote controller to control this unit or other devices by
pointing the remote controller at the remote controller
sensor on the amplifier, for example.
0
Also make sure to connect with the analog audio cable.
Centralized control cannot work correctly with only the
control jack connection.
0
The remote controller sensor on this unit stops working if
you connect a monaural miniplug cable (without resistor)
to the CONTROL IN jack of this unit.
0
The remote controller sensors on the other devices stop
working if you connect a monaural miniplug cable
(without resistor) to the CONTROL OUT jack of this unit.
0
If a Pioneer brand network player and amplifier is
connected by the CONTROL IN/OUT jack, you can
perform basic operations on this unit, the network player,
and amplifier on a smart phone app over a network.
(One example of connection)
a
CONTROL
IN
OUT
CONTROL
IN
OUT
a
This unit
Amplifier
Audio device
a
Monaural Miniplug Cables (without resistors)
SN29403157_PD-70AE_En.book 10 ページ ２０１７年８月２４日 木曜日 午後４時２１分