Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press F to select AUX.
Press
F
repeatedly until
AUX
appears in the
display.
2 Press
r
to turn auxiliary setting on.
AUX :ON
appears in the display.
#
To turn auxiliary setting off, press
q
.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
s headlights are turned on. You
can switch dimmer on or off.
1 Press F to select DIMMR.
Press
F
repeatedly until
DIMMR
appears in
the display.
2 Press
r
to turn dimmer on.
DIMMR :ON
appears in the display.
#
To turn dimmer off, press
q
.
Setting the rear output and
subwoofer controller
This unit
s rear output (rear speaker leads out-
put) can be used for full-range speaker
(
R-SP :FUL
) or subwoofer (
R-SP :S/W
) connec-
tion. If you switch the rear output setting to
the
R-SP :S/W
, you can connect a rear speaker
lead directly to a subwoofer without using an
auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
R-SP :FUL
). When rear output
are connected to full range speakers (when
R-SP :FUL
is selected), you can connect the
RCA subwoofer output to a subwoofer. In this
case, you can select whether to use the sub-
woofer controller
s (low pass filter, phase)
built-in
P/O :S/W
or the auxiliary
P/O :FUL
.
1 Press F to select R-SP.
Press
F
repeatedly until
R-SP
appears in the
display.
2 Press
r
or
q
to switch the rear out-
put setting.
Pressing
r
or
q
will switch between
R-SP :FUL
(full-range speaker) and
R-SP :S/W
(subwoofer) and that status will be displayed.
#
When no subwoofer is connected to the rear
output, select
R-SP :FUL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
R-SP :S/W
.
#
When the rear output setting is
R-SP :S/W
,
you cannot change the subwoofer controller.
3 Press
m
or
n
to switch the subwoo-
fer output or non fading output.
Pressing
m
or
n
will switch between
P/O :S/W
and
P/O :FUL
and that status will
be displayed.
Notes
!
Even if you change this setting, there is no
output unless you turn the non fading output
(refer to
Using non fading output
on page 59)
or subwoofer output (refer to
Using subwoofer
output
on page 58) in the audio menu on.
!
If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
Initial Settings
En
76
Section
14
