Initial Settings
1
Press SRC/OFF and hold until the unit
turns off.
2
Press M.C. to display the initial setting
menu.
3
Turn M.C. to select the initial setting.
After selecting, perform the following proce-
dures to set the initial setting.
FM step
(FM tuning step)
Normally, the FM tuning step employed by seek tun-
ing is 50 kHz. When AF or TA is on, the tuning step
automatically changes to 100 kHz. It may be prefer-
able to set the tuning step to 50 kHz when AF is on.
1
Press
M.C.
to display the setting mode.
2
Turn
M.C.
to select the FM tuning step.
100kHz
(100 kHz)
—
50kHz
(50 kHz)
3
Press
M.C.
to confirm the selection.
Auto PI
(auto PI seek)
The unit can automatically search for a different sta-
tion with the same programming, even during preset
recall.
1
Press
M.C.
to turn Auto PI seek on or off.
A-EQ Measurement
(auto-equalizing)
The auto-equalizer is an equalizer curve created by
auto EQ (refer to
page).
You can turn the auto-equalizer on or off.
Rear Speaker
(rear output and subwoofer setting)
This unit
’
s rear output (rear speaker leads output and
RCA rear output) can be used for full-range speaker
(
Full
) or subwoofer (
Subwoofer
) connection. If you
switch the rear output setting to
Subwoofer
, you can
connect a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker con-
nection (
Full
).
1
Press
M.C.
to display the setting mode.
2
Turn
M.C.
to change the setting.
Subwoofer
(subwoofer)
—
Full
(full-range speak-
er)
!
Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to
!
If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
3
Press
M.C.
to confirm the selection.
Demonstration
(demo display setting)
1
Press
M.C.
to turn the demo display on or off.
Video Signal
(video signal setting)
Be sure to adjust the video signal setting to one that
is suitable for your country.
1
Press
M.C.
to display the setting mode.
2
Turn
M.C.
to select an appropriate video signal.
NTSC
—
PAL
3
Press
M.C.
to confirm the selection.
BT Memory Clear
(resetting the Bluetooth wireless
technology module)
This function is available only for MVH-8200BT.
Bluetooth telephone data can be deleted. To protect
personal information, we recommend deleting this
data before transferring the unit to other persons. The
following settings will be deleted.
!
phone book entries on the Bluetooth telephone
!
preset numbers on the Bluetooth telephone
!
registration assignment of the Bluetooth tele-
phone
!
call history of the Bluetooth telephone
!
information of the connected Bluetooth telephone
!
PIN code
1
Press
M.C.
to display the setting mode.
2
Use
M.C.
to select
Yes
.
Turn to change the mode. Press to select.
Cleared
is displayed and the settings are deleted.
To cancel, select
No
.
!
While this function is in use, do not turn off
the engine.
En
31
Section
03
Operating
this
unit
Operating this unit
