Pioneer krp-m01, Service Manual

Page: 115 / 131

115
KRP-M01
5 6 7 8
5 6 7 8
A
B
C
D
E
F
8. EACH SETTING AND ADJUSTMENT
8.1 ADJUSTMENT REQUIRED WHEN THE UNIT IS REPAIRED OR REPLACED
1. At shipment, the unit is adjusted to its best conditions. Normally, it is not necessary to readjust even if an assembly is replaced. If the
adjustment is shifted or if it becomes necessary to readjust because of part replacement, etc., perform the adjustment as described below.
2. Any value changed in Service/Factory mode will be stored in memory as soon as it is changed. Before readjustment, take note of the
original values for reference in case you need to restore the original settings.
3. Use a stable AC power supply.
PCB Assy No. Assy Name
Ref No. Function Name Part No. Reason
A WV 2570
A WV 2572
MAI N BLOCK
Assy
A WV 2571
(A WW 1443)
FRO N T_IO
Assy
AXY1204 PO W ER
SUPPLY Unit
IC6001 SYSTEM IC (BCM7404) BCM7404XKPB11G-K
U0003 –– ––
IC6403 DT V Flash S29GL512P10TFIR1
-K (AGC1089)
IC5002 HDCP EEPROM BR24L02F V - W
IC5003 HDCP EEPROM BR24L02F V - W
IC5004 HDCP EEPROM BR24L02F V - W
IC7301 FRO N T HDCP EEPROM
IC7004 EMMA2 EEPROM
BR24L02F V - W
BR24L64F- W
IC6701 ARIA FLASH S29GL016A90TFIR2
-K (AGC1088)
IC6811 IF UCOM AGC1086
IC7202 EMMA2 FLASH S29GL032 N 90TFIO4
-K (AGC1087)
IC6201 BCM DDR SDRAM HY5DU121622DTP-D43-K
IC6202 BCM DDR SDRAM
IC6203 BCM DDR SDRAM
HY5DU121622DTP-D43-K
HY5DU121622DTP-D43-K
IC6204 BCM DDR SDRAM HY5DU121622DTP-D43-K
IC8501 PC EEPROM BR24L01AFJ- W
The maker forbids Pioneer from repairing
the Assy.
Because ID data (MAC address and data
on keys) have been stored
Because adjustments and data writing at
the level of production line are required
after replacement
Because adjustments and data writing at the level
of production line are required after replacement
Replacement of the whole Assy is re q uired when one of the followin g part
on the correspondin g Assy is in failure
Other assemblies N o adjustment required
PO W ER SUPPLY Unit
N o adjustment required
MAI N BLOCK Assy ( * ) Execute section [5-5] AUTO ADJUSTME N T of
6.2 [5] I N ITIALIZE.
When any of the followin g assemblies is replaced
( * ) : W hen replacing the MAI N BLOCK Assy, be sure to perform the FI N AL SETUP.