Pioneer Elite VSX-90TXV, Service Manual

Page: 20 / 233

VSX-1017AV-K
20
1 2 3 4
1 2 3 4
C
D
F
A
B
E
7 TV CONTROL buttons
T hese buttons are dedicated to control the T V assigned to
the TV CTRL button. T hus if you only have one T V to hook
up to this system assign it to the TV CTRL input source
button. I f you have two T Vs, assign the main T V to the TV
CTRL button.
TV

– Use to turn on/off the power of the T V.
TV VOL +/– – Use to adjust the volume on your T V.
INPUT SELECT – Use to select the T V input signal.
TV CH +/ – – Use to select channels.
8 Component control buttons
T he main buttons (

,

, etc.) are used to control a
component after you have selected it using the input
source buttons.
T he controls above these buttons can be accessed after
you have selected the corresponding input source button
(for example
DVD , DVR1 or TV ). T he following controls
can be accessed when listening to the built - in tuner:
MPX – Switches between stereo and mono reception
of FM broadcasts. I f the signal is weak then switching
to mono will improve the sound quality.
DISP – Switches between named station presets and
radio frequencies.
9 Receiver controls
THX
– Press to select a Home T HX listening mode.
STANDARD – Press for Standard decoding and to
N eo:6 options.
ADV.SURR – Use to switch between the various
surround modes.
STEREO/F.S.SURR – Switches between the stereo
playback mode and the Front Stage Surround
Advance mode.
AUTO SURR – Press to select the Auto Surround
mode or the Stream Direct mode.
Stream Direct playback bypasses the tone controls
and any other signal processing for the most
accurate reproduction of a source.
ACOUSTIC EQ – Press to select an Acoustic
Calibration EQ setting.
SIGNAL SEL – Use to select an input signal.
13 Character display (LCD)
T his display shows information when transmitting
control signals.
T he following commands are shown when you ’ re setting
the remote to control other components.
SETUP – I ndicates the setup mode, from which you
choose the options below.
PRESET – See Selecting preset codes directly.
MULTI OP – See Multi O peration and System O ff.
SYS OFF – See Multi O peration and System O ff.
DIRECT F – See Direct function.
RESET – See Resetting the remote control presets.
READ ID – See Confirming preset codes.
14 RECEIVER
Switches the remote to control the receiver (used to
select the green commands above the number buttons
(
ANALOG ATT , etc.)). Also use this button to set up
surround sound.
With
SHIFT , this selects the MUL TI-ZON E control. 90 T XV O nly
15 VOL +/ –
Use to set the listening volume.
16 MUTE
Mutes the sound or restores the sound if it has been
muted (adjusting the volume also restores the sound).
17 EFFECT/CH SEL and LEVEL +/ –
Press repeatedly to select a channel, then use +/ – to
adjust the level. Also adjusts the level of the Advanced
Surround effects, the Dolby Pro Logic
II x Music and
N eo:6 Music parameters and the sound delay setting.
You can then use the +/ – buttons to make these
adjustments.
10 MULTI OPE
Use this button to perform multi operations.
11 SHIFT
Press to access the controls outlined in white boxes (for
example,
INPUT SELECT ), or to display the currently
selected input source in the remote control LCD.
12 SOURCE

Press to turn on/off other components connected to the
receiver.
switch between the various Pro Logic II x and