!
It is imperative that non-installed speakers
be set to
OFF
.
!
Set the front or rear speaker to
LARGE
if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1
Use MULTI-CONTROL to select FRONT.
Refer to
Introduction of DSP adjustments
on
page 64.
2
Push MULTI-CONTROL left or right to
select the speaker to be adjusted.
FRONT
(front speakers)
—
CENTER
(center
speaker)
—
REAR
(rear speakers)
—
SUB WOOFER
(subwoofer)
—
PHASE
(subwoo-
fer setting)
#
You can switch to
PHASE
only when the sub-
woofer has been set to
ON
.
3
Push MULTI-CONTROL up or down to
select the correct size for the selected
speaker.
SMALL
(small)
—
LARGE
(large)
—
OFF
(off)
#
You cannot select
OFF
, when
FRONT
(front
speakers) have been selected.
#
You can select
ON
or
OFF
, when
SUB WOOFER
(subwoofer) has been selected.
#
You can switch
REVERSE
(reverse phase) or
NORMAL
(normal phase), when
PHASE
(subwoo-
fer setting) has been selected.
Correcting the subwoofer
’
s phase
If trying to boost the bass output of the sub-
woofer doesn
’
t do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer
’
s output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1
Use MULTI-CONTROL to select FRONT.
Refer to
Introduction of DSP adjustments
on
page 64.
2
Push MULTI-CONTROL left or right to
select SUB WOOFER.
FRONT
(front speakers)
—
CENTER
(center
speaker)
—
REAR
(rear speakers)
—
SUB WOOFER
(subwoofer)
—
PHASE
(subwoo-
fer setting)
3
Push MULTI-CONTROL up to turn the
subwoofer output on.
4
Push MULTI-CONTROL right to select
PHASE (subwoofer setting).
5
Push MULTI-CONTROL up or down to
select the phase of subwoofer output.
Push
MULTI-CONTROL
up to select
NORMAL
(normal phase). Push
MULTI-CONTROL
down
to select
REVERSE
(reverse phase).
Note
When playing a 2-channel mono source with Pro
Logic II turned on, there may be occasions when
the following will occur:
!
No audio is outputted if the center speaker
setting is
SMALL
or
LARGE
and no center
speaker is installed.
!
Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL
or
LARGE
.
Selecting a cross-over frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
SMALL
, you can select a
frequency, under which sounds are repro-
duced through a
LARGE
speaker or subwoo-
fer.
1
Use MULTI-CONTROL to select HPF.
Refer to
Introduction of DSP adjustments
on
page 64.
Available accessories
En
71
Section
03
A
vailable
accessories
