DRM-ULV16
20
1
2
3
4
1
2
3
4
C
D
F
A
B
E
1
Unpack the rear terminal block.
2
Pass the wires through the opening first, then secure the
block using the four screws that were removed in Step
ø
-
6
.
Installation of the rear terminal block
5
2
2
1
2
Rear terminal block
Rear terminal block
Flat cable clamp
Flat cable (GRN/GRY)
Flat cable (GRN/GRY)
CONV unit block
CONV unit block
2
2
3
2
Note:
Care must be taken not to bump the board against
the plate during attachment.
Note:
Be careful not to damage the wires with the
sharp edge of the plate when you pass the wires
through the opening.
Note:
Care must be taken not to snag the wires.
(See Step
π
-
1
.)
Note:
Be careful that the card spacers do not press
against the flat cable (GRN/GRY).
1
Unhook the flat cable clamp and fix the flat cable (GRN/GRY)
with it.
(If the flat cable clamp has been removed in Step
[
-
4
,
go to the next step.)
2
Set the CONV unit block in place, referring to Step
[
-
3
.
3
Secure the block in place with the three supplied screws,
in the order indicated below (Center
Left
Right).
Installation of the CONV unit block
6
-1
3
-2
3
-3
IDSB Unit
Note:
While disassembling/reassembling the IDSB unit, be
careful not to apply any external pressure on it, including
on the parts specifically mentioned in the instructions.
