DRM-ULV16
21
5
6
7
8
5
6
7
8
C
D
F
A
B
E
4
Connect the flat cables.
5
Set the LVD connector guard Assy in place then secure it
with the supplied screw.
6
Unhook the cable clamp and bind the Connector Assy (4P)
for the ID and the Connector Assy (2P) for the terminating
switch together with it.
4
4
4
7
7
7
8
8
8
8
5
9
5
6
Flat cable
(GRN/GRY)
Flat cable
(ORG/WHT)
LVD connector guard Assy
Cable clamp
Connector Assy (2P)
Connector Assy (4P)
Shaft
Drilled hole
CONV Unit
CONV Unit
CONV Unit
CONV Unit
MMCB Unit
MMCB Unit
CN114
CN906
CN910
CN912
CN911
CN903
CN101
CN113
CN904
CN905
Note:
Be sure to connect the tagged side of the flat cable
(GRN/GRY) to the CN114 on the MMCB unit.
While plugging in the connector, hold the rear of the
MMCB unit so that the board will not bend.
Note:
Be sure to pass the shaft through the flat cable
(ORG/WHT) then insert the end of it into the drilled hole
of the panel. After confirming that the end of the shaft is
securely inserted in the drilled hole, tighten the screw.
Note:
Bind the wires at as far up as possible.
7
Connect the cables to the connector for the ID (CN904_4P),
the Connector for the terminating switch (CN905_2P),
and the connector for the power (CN912_6P).
8
Connect the CN113 on the MMCB unit and the CN903 on the
CONV unit using the supplied Connector Assy (5P), as well
as the CN101 on the MMCB unit and CN911 on the CONV
unit using the supplied Connector Assy (6P).
9
Bind the wires with the supplied binder.
10
Reattach the side panel of the changer.
Flat cable
(ORG/WHT)
Connector Assy (6P)
Connector Assy (5P)
