En
6
Part names and functions
Rear panel
1
3
4
3
4
4
3
4
3
5
5
6
7
8
2
d
e
a
b
h
9
c
g
f
1
POWER button (page 11 )
Turns this unit’s power on and off.
2
RETURN terminals (page 10 )
Connect to the output terminal of an external effector. When the
[
L (MONO)
] channel only is connected, the [
L (MONO)
] channel
input is simultaneously input to the [
R
] channel.
3
PHONO terminals (page 9 )
Connect to a phono level (MM cartridge) output device. Do not input
line level signals.
To connect a device to the [
PHONO
] terminals, remove the short-
circuit pin plug inserted in the terminals.
Insert this short-circuit pin plug into the [
PHONO
] terminals when
nothing is connected to them to cut external noise.
4
LINE terminals (page 9 )
Connect to a DJ player or a line level output component.
5
SIGNAL GND terminal (page 9 )
Connects an analog player’s ground wire here. This helps reduce
noise when the analog player is connected.
6
MIC2 terminal (page 9 )
Connects a microphone here.
7
MIC1 terminal (page 9 )
Connects a microphone here.
8
Kensington security slot
9
DIGITAL IN terminal (page 9 )
Connect these to the digital coaxial output terminals on DJ players,
etc. The sound may be momentarily interrupted when the output
signal sampling frequency is switched.
a
DIGITAL MASTER OUT terminal (page 10 )
Connect this to the digital terminal of a preamplifier, etc. It outputs
the master channel audio in SPDIF format.
Take careful not to
connect it to an analog input terminal by mistake.
b
LINK terminal (page 9 )
Connect this to the LINK terminals of a Pioneer DJ player or the LAN
ports of a computer with rekordbox installed (PRO DJ LINK).
To connect multiple devices, use a switching hub (commercially
available).
Use a 100Base-TX-compatible switching hub. Some switching hubs
may not operate properly.
c
BOOTH terminals (page 10 )
These are output terminals for a booth monitor.
When only [
L (MONO)
] is connected, monaural audio is output.
d
REC OUT terminals (page 10 )
These are output terminals for recording.
e
MASTER2 terminals (page 10 )
Connect these to the analog input terminals of a power amplifier, etc.
f
MASTER1 terminals (page 10 )
Connect these to the analog input terminals of a power amplifier, etc.
Be sure to use these as balanced outputs.
Be careful not to acci-
dentally insert the power cord of another unit.
g
SEND terminals (page 10 )
Connect to the input terminal of an external effector. When the
[
L (MONO)
] channel only is connected, a monaural audio signal is
output.
h
AC IN
Connects to a power outlet using the included power cord. Wait until
all connections between the equipment are completed before con-
necting the power cord.
Be sure to use the included power cord.
WARNING
The short-circuit pin plugs out of the reach of children and infants. If
accidentally swallowed, contact a doctor immediately.
