En
11
English
Operation
Basic Operation
Outputting sound
1 Press [POWER] button.
Turn on the power of this unit.
2 Switch the input selector switches.
Selects the input sources for the different channels from among the
devices connected to this unit.
3 Turn the [TRIM] control.
Adjusts the level of audio signals input in each channel.
The corresponding channel level indicator lights when audio signals are
being properly input to that channel.
4 Move the channel fader away from you.
Adjusts the level of audio signals output in each channel.
5 Switch the [CROSS FADER ASSIGN (A, THRU, B)]
selector switch.
Switches the output destination of each channel.
6 Set the crossfader.
This operation is not necessary when the [
CROSS FADER ASSIGN
(
A
,
THRU
,
B
)] selector switch is set to [
THRU
].
7 Turn the [MASTER LEVEL] control.
Audio signals are output from the [
MASTER1
] and [
MASTER2
]
terminals.
The master level indicator lights.
Monitoring sound with headphones
1 Connect headphones to the [PHONES] terminal.
2 Press the [CUE] button(s) for the channel(s) you want
to monitor.
3 Switch the [MONO SPLIT, STEREO] selector switch.
4 Turn the [MIXING] control.
This adjusts the monitor volume balance of the sound of channels for
which the [
CUE
] button is pressed and the sound of the [
MASTER
]
channel.
5 Turn the [LEVEL] control for [HEADPHONES].
The sound of the channels for which the [
CUE
] button is pressed is
output from the headphones.
!
When the [
CUE
] button is pressed again, monitoring is canceled.
Using a microphone
1 Connect a microphone to the [MIC1] or [MIC2]
terminal.
2 Set the [OFF, ON, TALK OVER] selector switch to [ON]
or [TALK OVER].
!
When set to [
TALK OVER
], the sound of channels other than the
[
MIC
] channel is attenuated by 18 dB (default) when a sound of –10
dB or greater is input to the microphone.
!
The sound attenuation level of [
TALK OVER
] can be changed with
[
UTILITY
]. For details on how to change the level, see the Operating
Instructions.
!
The TALK OVER mode can be switched to normal mode or advanced
mode. For details on how to change the mode, see the Operating
Instructions.
3 Turn the [MIC1 LEVEL] or [MIC2 LEVEL] control.
Adjust the level of the sound output from the [
MIC
] channel.
!
Pay attention that rotating to the extreme right position outputs a
very loud sound.
4 Input audio signals to the microphone.
Audio is output from the [
BOOTH
]
terminal
Turn the [BOOTH MONITOR] control.
Adjusts the level of audio signals output from the [
BOOTH
] terminal.
