DJM-700-S
37
5
6
7
8
5
6
7
8
C
D
F
A
B
E
How to Update the DSP Program/Date
Notes:
• Please turn power of DJM-700 into OFF.
• If updating of both the DSP program and data is necessary, the following updating procedures must be performed
separately for the program and data.
1) Referring to “How to Update the Main Microcomputer,” download the firmware for updating the DSP program/data.
Use the parameter file “7
8
F1166.prm” for the main microcomputer.
• Please turn power of DJM-700 into OFF.
2) After downloading of the firmware is completed, disconnect the MI
N
ICUBE2 from the DJM-700 then turn the
DJM-700
O
N
.
Updating of the DSP program or data will be automatically started and completed.
Caution!!
If the DJM-700 is on during the download, the DSP update is performed immediately after the MI
N
ICUBE2 is
disconnected. (This is because the DJM-700 is in reset status when connected to the host machine by the MI
N
ICUBE2
and reset status is cleared when the DJM-700 is disconnected.)
In this situation, do not turn off the power until the following DSP update compete screen is displayed.
Do not turn off the power during the update. Otherwise, the DSP may not restart.
• Modifying the FL display during the update (for the DSP program update)
Note:
After updating is completed, enter Mode 1 (Confirmation of software version) of Test mode
to check if the versions have been all updated.
3)
After DSP updating is completed, perform the firmware update of the main microcomputer.
If it does not perform this update, this unit cannot use the normal function.
* "DATA" is displayed instead of "PROGRAM" while updating the DSP data.
PIONEER
Power on
UP END
Update complete
←
You may turn off the power once this screen appears.
PROGRAM
0
0
PROGRAM
0
10%
PROGRAM
0
72%
PROGRAM
0
100%
W
hile downloading the update
WAIT
0
WRITING
0
0
W
riting to the flash ROM
Caution!!
Never turn off the power while loading
data or writing to the ROM.