2
Use MULTI-CONTROL to select FM STEP.
3
Press MULTI-CONTROL to select the FM
tuning step.
Pressing
MULTI-CONTROL
repeatedly will
switch the FM tuning step between 50 kHz
and 100 kHz. The selected FM tuning step will
appear in the display.
Note
The tuning step remains at 50 kHz during manual
tuning.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
kHz to 1 602 kHz allowable) to 10 kHz (530 kHz
to 1 640 kHz allowable).
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select
AM STEP.
3
Press MULTI-CONTROL to select the AM
tuning step.
Pressing
MULTI-CONTROL
repeatedly will
switch the AM tuning step between 9 kHz and
10 kHz. The selected AM tuning step will ap-
pear in the display.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select
WARNING.
3
Press MULTI-CONTROL to turn warning
tone on.
#
To turn warning tone off, press
MULTI-CONTROL
again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source
on page 48.
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select AUX1/
AUX2.
3
Press MULTI-CONTROL to turn AUX1/
AUX2 on.
#
To turn AUX off, press
MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put) can be used for full-range speaker (
FULL
)
or subwoofer (
SUB W
) connection. If you
switch the rear output setting to
SUB W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
FULL
).
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select REAR SP.
Initial Settings
En
44
Section
04
