#
If the connection fails,
ERROR
is displayed. In
this case, check the cellular phone and try again.
#
If three cellular phones have already been
paired, the pairing assignment selection display
will appear. Select one assignment to pair the
new phone. The newly paired phone overwrites
the previously paired phone. The assignment se-
lection operation is the same as Step 3 to 4 of
Pairing a connected cellular phone
on this page ex-
cept for the operation below.
!
Switching the BD address and device name
8
Use MULTI-CONTROL to decide to
download the phone book from your cellu-
lar phone or not.
Push
MULTI-CONTROL
left or right to select
NO
(No) or
YES
(Yes).
Press
MULTI-CONTROL
to decide.
When you select
YES
, this unit changes to
PH BOOK DOWNLOAD
and the download op-
eration automatically begins. After complet-
ing,
DATA DOWNLOADED
is displayed.
According to the circumstances, this unit
changes to
PH BOOK TRANSFER
. In this case,
refer to step 4 on
Transferring entries to the
phone book
on page 36.
#
When you select
NO
, the display reverts to
normal.
Connecting a paired cellular phone
1
Display the connection menu.
Refer to
Introduction of connection and regis-
tration
on page 26.
2
Turn MULTI-CONTROL to select
PAIRED PHONE.
#
Push
MULTI-CONTROL
up or down to select a
desired phone.
#
Push
MULTI-CONTROL
left or right to switch
the device name, BD address, group name and
group ID.
3
Press MULTI-CONTROL to start connec-
tion.
While connecting,
CONNECTING
is displayed.
If the connection is established,
CONNECTED
is displayed.
After connected, this unit automatically
changes to
PH. BOOK DL
(phone book down-
load confirmation) display.
#
If the connection fails,
ERROR
is displayed. In
this case, check the cellular phone and try again.
4
Use MULTI-CONTROL to decide to
download the phone book from your cellu-
lar phone or not.
Push
MULTI-CONTROL
left or right to select
NO
(No) or
YES
(Yes).
Press
MULTI-CONTROL
to decide.
When you select
YES
, this unit changes to
PH BOOK DOWNLOAD
and the download op-
eration automatically begins. After complet-
ing,
DATA DOWNLOADED
is displayed.
#
When you select
NO
, the display reverts to
normal.
Disconnecting a cellular phone
1
Display the connection menu.
Refer to
Introduction of connection and regis-
tration
on page 26.
2
Use MULTI-CONTROL to select
DISCONNECT PHONE.
3
Press MULTI-CONTROL to disconnect a
cellular phone from this unit.
After disconnection is completed,
DISCONNECTED
is displayed.
Pairing a connected cellular phone
Pairing is usually performed automatically dur-
ing the connection operation. You only need to
perform this operation manually when your
phone is connected temporarily for any reason.
We recommend you pair the phone to this unit
to make best use of the technology.
1
Display the connection menu.
Refer to
Introduction of connection and regis-
tration
on page 26.
2
Use MULTI-CONTROL to select
SET PHONE.
Operating this unit
En
28
Section
02
