Adjusting initial settings
1
Press SRC/OFF and hold until the unit
turns off.
2
Press SRC/OFF and hold until FM STEP
appears in the display.
3
Turn MULTI-CONTROL to select one of
the initial settings.
FM STEP
(FM tuning step)
—
AUTO PI
(auto PI
seek)
—
AUX1
(auxiliary input 1)
—
AUX2
(aux-
iliary input 2)
—
SW CONTROL
(rear output
and subwoofer controller)
—
EVER SCROLL
(ever scroll)
—
BT AUDIO
(Bluetooth audio)
—
PIN CODE INPUT
(pin code input)
—
BT VER INFO
(Bluetooth version information)
—
TITLE SETTING
(multi language)
—
POWER SAVE
(power save)
Notes
!
You can also perform the same operations by
pushing
MULTI-CONTROL
up or down.
!
To return to the previous display, press
DISP/BACK/SCRL
.
!
To cancel initial settings, press
BAND/ESC
.
!
BT AUDIO
,
PIN CODE INPUT
and
BT VER INFO
can be selected only when Blue-
tooth adapter (e.g., CD-BTB200) is connected
to this unit.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1
Use MULTI-CONTROL to select FM STEP
in the initial setting menu.
Refer to
Adjusting initial settings
on this page.
2
Press MULTI-CONTROL to display the
setting mode.
#
Press
DISP/BACK/SCRL
to return to the pre-
vious display.
3
Turn MULTI-CONTROL to select the FM
tuning step.
Turning
MULTI-CONTROL
switches the FM
tuning step between 50 kHz and 100 kHz while
AF or TA is on. The selected FM tuning step ap-
pears in the display.
#
You can also perform the same operations by
pushing
MULTI-CONTROL
up or down.
4
Press MULTI-CONTROL to determine
the selection.
#
Even if the menu has been cancelled before
determination, operation is settled.
Note
The tuning step remains at 50 kHz during manual
tuning.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1
Use MULTI-CONTROL to select AUTO PI
in the initial setting menu.
Refer to
Adjusting initial settings
on this page.
2
Press MULTI-CONTROL to turn Auto PI
seek on.
#
To turn Auto PI seek off, press
MULTI-CONTROL
again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source
on page 33.
1
Use MULTI-CONTROL to select AUX1/
AUX2 in the initial setting menu.
Refer to
Adjusting initial settings
on this page.
Initial Settings
En
29
English
Section
04
