#
To turn high pass filter off, press
MULTI-CONTROL
again.
4
Push MULTI-CONTROL left or right to
select cut-off frequency.
50
—
63
—
80
—
100
—
125
(Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
Boosting the bass
Bass boost function boosts the bass level of
sound.
1
Press and hold SW/BASS to display
BASS BOOST setting mode.
2
Push MULTI-CONTROL up or down to
select a desired level.
0
to
+6
is displayed as the level is increased or
decreased.
Note
You can also switch to this setting mode in the
menu that appears by using
MULTI-CONTROL
.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
!
Settings are based on the FM volume level,
which remains unchanged.
1
Compare the FM volume level with the
level of the source you wish to adjust.
2
Display the audio menu.
Refer to
Introduction of audio adjustments
on
page 38.
3
Use MULTI-CONTROL to select SLA.
4
Push MULTI-CONTROL up or down to
adjust the source volume.
Each time
MULTI-CONTROL
is pushed up or
down, source volume increases or decreases.
+4
to
–
4
is displayed as the source volume is
increased or decreased.
Notes
!
The AM volume level can also be adjusted
with source level adjustments.
!
The built-in CD player and the multi-CD player
are set to the same source level adjustment
volume automatically.
!
External unit 1 and external unit 2 are set to
the same source level adjustment volume
automatically.
Audio Adjustments
En
41
English
Section
09