15
En
Connections
and
part
names
f
HEADPHONES MIXING control
Adjusts the balance of the monitor volume between the sound of the
channels for which the headphones [
CUE
] button is pressed and the
sound of the master channel.
g
MASTER CUE button
Turns monitoring of the master output’s sound on and off.
h
SAMPLER VOLUME fader
Adjusts the sampler’s overall sound level.
Effect section
This section is used to control the two effect units (FX1 and FX2).
Controls and buttons to operate the FX1 unit are located on the left side
of the controller, those to operate the FX2 unit are located on the right
side of the controller. The channels to which the effect is to be applied
are set using the effect assign buttons .
1
1
1
2
3
3
3
4
1
Effect parameter controls
These adjust the effects’ parameters.
2
FX BEATS control
Adjusts the effect time.
3
Effect parameter buttons
Press:
Turns the effect on and off or switches the parameter.
[
SHIFT
] + press:
Switches the effect type.
4
TAP button
Press:
The BPM used as the base value for the effect is calculated by the
interval at which the button is tapped with a finger.
When the button is pressed and held, the effect time is reset.
[
SHIFT
] + press:
Switches the effect mode.
!
This function (Effect Mode Switching) cannot be used with
Serato DJ Ver. 1.0. It is scheduled to be supported in a future
version update.
To monitor the effect sounds
When the [
HEADPHONES MIXING
] control is turned to the [
CUE
] side,
the Serato DJ software’s effect sounds are not output in the sound of
channels whose headphones [
CUE
] button is pressed. To monitor the
Serato DJ software’s effect sounds, turn the [
HEADPHONES MIXING
]
control to the [
MASTER
] side, turn on the [
MASTER CUE
] button and
monitor the effect sound with the master output’s sound.
