![background image](http://html.mh-extra.com/html/pioneer/avic-f930bt/avic-f930bt_service-manual_326126154.webp)
AVIC-X930BT/XNUC
154
1
2
3
4
1
2
3
4
C
D
F
A
B
E
T-case washer
Drive gear
Fig. 1
Fig. 2
b.Open-lock state
There is a
space
There is
no space
c.Clamp state with no disc loaded
A
CRG Mecha_Bringing into the Clamp State with No Disc Loaded
1.Remove the T-case washer and then remove the drive gear. (Fig. 1)
2.Lift the clamp arm assy until it is in the state shown in Fig. 2_b (open-lock state).
3.Put your finger on the area A of Fig. 2_c and then slide it to the direction of the arrow (the direction of the playing state).
4.Push down the clamp arm.
(Precaution) When bringing the CRG mecha into the ejecting state again, install the drive gear after sliding the drive
lever and bringing it to the ejecting state, in order to prevent the cog of the pinion in the drive gear from chipping at the
time of its installation.
a.Ejecting state
Summary of Contents for AVIC-F930BT
