6
The remote control may not function properly in direct
sunlight.
Important
Do not store the remote control in high temperatures or
direct sunlight.
Do not let the remote control fall onto the floor, where it
may become jammed under the brake or accelerator.
1 Turn the ignition switch OFF.
2 Press the
RESET
button with a pen tip or other
pointed implement.
Refer to
Checking part names and functions
on page 7
Settings and recorded contents are reset to the factory settings.
About this manual
This manual uses diagrams of actual screens to describe opera-
tions. However, the screens on some units may not match those
shown in this manual depending on the model used.
Meanings of Symbols Used in This
Manual
X0000BT
This indicates model name that are supported
the described operations.
This indicates to touch an appropriate soft key
on the touch screen.
HOLD
This indicates to touch and hold an appropriate
soft key on the touch screen.
This indicates that there is a reference or
supplementary for the key or screen.
Protecting your unit from theft
The front panel can be detached to deter theft.
Important
Handle the front panel with care when removing or
attaching it.
Avoid subjecting the front panel to excessive shock.
Keep the front panel out of direct sunlight and high
temperatures.
If removed, replace the front panel on the unit before
starting up your vehicle.
To avoid damaging the device or vehicle interior, remove
any cables and devices attached to the front panel before
detaching it.
Removing the front panel
1 Pinch the top and bottom of its right side and
pull the front panel out.
Take care not pinch it too tightly or to drop it, and also avoid
contact with water or other fluids to prevent permanent damage.
Re-attaching the front panel
1 Slide the front panel to the left.
The front panel and the head unit are connected on the left side.
Make sure that the front panel has been properly connected to
the head unit.
2 Press the right side of the front panel until it is
firmly seated.
If you can’t attach the front panel to the head unit successfully,
try again.
Forcing the front panel into place may result in damage.
Use and care of the remote
control
Installing the battery
Slide the tray on the back of the remote control out and insert the
battery with the plus (+) and minus (–) poles aligned properly.
When using for the first time, pull out the film protruding
from the tray.
WARNING
Do not ingest the battery, Chemical Burn Hazard.
This product, including the supplied remote control,
contains a coin/button cell battery. If the coin/button cell
battery is swallowed, it can cause severe internal burns in
just two hours and can lead to death.
Keep new or used batteries out of the reach of children.
If the battery is swallowed or placed inside any part of the
body, consult a doctor immediately.
If the battery compartment does not close securely, stop
using the product and keep it away from children.
Batteries (battery pack or batteries installed) must not be
exposed to excessive heat such as sunshine, fire or the
like.
CAUTION
Remove the battery if the remote control is not used for a
month or longer.
There is a danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent type.
Do not handle the battery with metallic tools.
Do not store the battery with metallic objects.
If the battery leaks, wipe the remote control completely
clean and install a new battery.
When disposing of used batteries, comply with
governmental regulations or environmental public
institutions’ rules that apply in your country/area.
“Perchlorate Material – special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable
to California, U.S.A.)”
Using the remote control
Point the remote control in the direction of the front panel to
operate.
< CRD4921-A >
< CRD4921-A >
Precaution
Precaution
6
Summary of Contents for AVH-X6850DVD
Page 167: ... CRD4921 A 167 ...
