Pioneer Eclipse CleanStar CS 2000, Operator'S Manual

Page: 4 / 26

General Instructions
Proper use of the CS2000
As soon as the machine arrives, please inspect the exterior and all moving parts to verify that no damage
has occurred during transport. In case of missing or damaged parts, contact the Manufacturer or Authorized
Distributor immediately.
Use the scrubber to clean floors with any covering. Maximum performance can be achieved with proper use
and maintenance.
Handling of Packed Machine
The machine is supplied packed on a pallet, closed in a box made of plywood or paperboard. Please see
the Features and Specifications section for information on weight and size. A black arrow on the box
indicates the barycenter position. The forks of the lift truck or of the transpallet should be placed so that the
black arrow indicated on the packing is about in the center of the forks. The palletized box should be
handled with extreme caution; avoid impacts or lifting to extreme heights without reason. Do not stack the
boxes.
Unpacking the Machine
Unpack the machine with caution.
• Cut the straps with the proper cutting tool, being careful of spring
back.
• Remove the clips on the paperboard base which bind the paperboard
to the pallet by using a screwdriver or a proper tool, and lift the
paperboard.
• In case of package made of plywood, remove the clips on the sides
and on the base of each panel as well.
• Remove the other clips fastening the machine in the same manner.
• Bring the machine to ground level by means of a metallic or wooden
ramp.
Handling of the Unpacked Machine
Check the unpacked machine and install the batteries. If the machine must be handled for a short transport
after being used, detach the battery cables and remove pad/brush and squeegee. For a longer transport, it is
recommended to pack the machine again in its original box. The machine can be thrust-moved for short
distances.
General Instructions
Before using the machine, Pioneer Eclipse strongly recommends that all operators read the General Safety
Standards in this manual.
3