When handling coolants, risks linked to hazardous substances cannot be avoided. Observe the
manufacturer's and/or your company's instructions and recommendations referring to safe coolant
handling.
SUPPLY HOSE
VALVE
MESH
COOLANT TANK
DRAINAGE HOSE
SETTING CONTAINER
OVERFLOW OPENING
PUMP
Set the guide heads perpendicular to the bars and tighten them. If you fail to achieve perpendicularity, the saw blade will either keep
sliding off or running into the wheels. Remove the protective covers of the saw blade and remove the back cover of the arm. Connect
the machine to the mains and carry out a short saw blade trial run. Disconnect the machine from the mains and secure it against
restarting. Remove the protective covers of the saw blade and the back cover of the arm. Check the placement of the saw blade on
the wheels and in guide heads. Make a correction, if necessary - see section 4.5. Remove the protective covers of the saw blade and
remove the back cover of the arm. Connect the machine to the mains and carry out the cutting. You can watch the video with
instructions on www.pilous.cz.
4.
7
.
Cooling system
(only in ARG 130 TK (super), ARK 130 K (super))
The pump and the coolant tank are the basic elements of the cooling system. In ARG 130 K, you can remove the coolant tank from the
machine base without the pump. The coolant pump conveys the coolant via hoses, valves and guide heads to the saw blade. The
volume of the coolant is regulated by the valves on the guide heads. The coolant cools down and lubricates the saw blade and flushes
away metal chips. The pump switches on and off when the saw blade drive is started or shut down. There is a setting container in the
the coolant tank, which needs to be cleaned during regular checks depending on the material to be cut. It is important that the pump is
always immersed in the coolant that facilitates its cooling.
If the level of the coolant gets too low during cutting, the pump will be
irreparably damaged.
Summary of Contents for ARG 105 mobil
Page 2: ......
