8
In order to disconnect the inserted cable, you must first press the small latch lever on
the connector and then remove the connector from the socket. Carefully place the
circuit board back inside the housing. Close the housing and screw the cover back
on with a suitable screwdriver. Ensure that the cable is properly and that the sealing
of the radio receiver is in its proper position. Now connect the cable to the digital
railway center or the driver controller (See the corresponding Operating Instructions)
laid.
Fig. 1: Options of connection
2.2 Mounting:
The radio receiver can be fastened with the 4 strips located on the sides.
2.3 Operation:
When the unit is switched on and idle, the LED blinks (long on, long off), thereby
indicating that there is not yet a connection to the radio remote control.
As soon as a radio remote control is recognized, the LED illuminates without
interruption.
During operation for the first time, after a default reset, or if a new device should
to be registered, the LED blinks symmetrically fastly. The radio receiver can be
operated with up to four digital handheld controllers simultaneously.
Operating State of the STATUS LED
On (permanent)
Regular operation with one or more
transmitters
Flashing (symmetric fast)
Receiver searches for transmitters,
e.g. when first switched on, after
factory reset or if a new device is to be
registered via the push-button.
Flashing (symmetric slow)
Radio receiver Standby after switching
on or if no transmitter is active for a
long time.
Analog-Plug
(for #35002)
Digital-Plug
(for #35010)
DIP-Switch
Push-Button
35018-90-7000_2019.indd 8
22.05.19 08:24
