USE OF THE SAFETY BELTS
12. The stroller is equipped with a retaining syste
m with five anchoring
points, consisting of two shoulder straps, two wais
t belt and a crotch
strap with buckle, already assembled.
WARNING:
To adopt the retaining system to the body of the ch
ild, it is
possible to adjust them!
Fig 19
After laying the child in the stroller, fasten the belts as follow : as the first slide the buckle of
the right shoulder
belt into the central buckle and secure it with the
right waist belt, repeat the same action even for the left part
of the retraining system. Adjust the length of the
belts, making sure they adhere to your child’s shoulders and
body.
To unfasten the restrain system press the central b
utton.
WARNING:
Always use the restraint systems. For the safety of your child use all five fixing points of the
safety harness belts.
WARNING:
To ensure the safety of your child, use the safety
belts at all times.
For further safety, the stroller is equipped wit
h ‘’D’’-shaped rings to allow hooking an additiona
l safety belt,
compliant with BS 6684 standard. The rings are loca
ted inside the stroller’s seat on the right and lef
t side
Note: When use the winter foot-muff, pass the retaining system by the holes in the foot-muff as the fi
rst. For
their settings follow the instructions given above in the article “USE OF THE SAFETY BELTS”.
REMOVING THE SAFETY BELTS
13. The safety belts can be removed (to be washed or used in pram configuration).
If you want to remove the safety belt, it is necessary to stretch the clip-foot strip and pull it thro
ugh the hole in
the seat outwards, then pull the buckle shoulder straps and pull them through the holes in the backrest
outwards. The waist belts are firmly attached to the stroller, so for the pram configuration cover the
waist belt
by the extra padding.
After removing the seat belt, make sure that the ne
w installations would be passed through anchor points
correctly. For new installation, please follow the steps below carefully:
Pull the clip through the hole for between-foot belt. Make sure that the buckle pass through the hole
and the
belt with the central buckle was turned towards you.
After that, pull the buckle of the shoulder belt th
rough the hole in the backrest and secure it, the same repeat
for the second shoulder belt.
WARNING:
At the end of the assembly, the belts must be adjusted once again according to the size of your
child.
PARKING BRAKE
14. The stroller is equipped with pedal parking brake located on the
rear axle. To engage the parking brake, press the pedal downward with
one foot. To disengage the parking brake, push the
pedal upward, see Fig 20.
WARNING:
Always use the brake when not moving. Never leave the stroller on a
sloping surface with your child inside it, even if
the parking brake is engaged.
WARNING:
After engaging the parking brake, make sure
the brakes are
properly enabled on both rear wheels.
Fig 20
EXTRA PADDING OF THE SEAT
15. To use it during the early months of your child’s life, use the seat extra padding. The seat paddi
ng must be
assembled in stroller configuration.
To properly position the safety belts on the stroller’s backrest, refer to paragraph ‘’USE OF THE SAFE
TY
BELTS IN STROLLER CONFIGURATION’’.
At this point, thread the belts in the relative slots located on the extra padding. Repeat the same op
eration for
the waist belt and the crotch strap as mentioned in the paragraph ‘’USE OF THE SAFETY BELTS IN
STROLLER CONFIGURATION’’.
COMFORT KIT
The stroller includes a comfort kit containing 2 sh
oulder strap pads (A), a crotch strap cover pad (B).
For assembly, thread the shoulder straps in the slo
ts as shown in Fig 22, making sure you do not fit
the
vertical seam to the outside. The shoulder straps can be adjusted according to your child’s size.
Insert the crotch strap in the relative slot as sho
wn in fig. 23.
Fig 21
Fig 22
Fig 23
LEGCOVER / PRAM APRON
Fig 24
Fig 25
Fig 26
17. This component (Fig. 24) can be used in two different ways: as the leg-cover in stroller configuration (fig.
25) and as an apron in pram configuration (fig. 26)
.
To secure it, use the zipper and fasten it to the s
troller. Leg-cover/pram apron is equipped with Velcro, it allow
to attached it around the bumper bar.
FOLDING THE STROLLER
18. To fold the stroller and make it more compact, unlock the front wheels so they swivel, and remove
the
seat.
If you want to remove the seat, press the lock on the bottom of the joints of the seat and pull it upw
ards.
15-0229_Navod_Gmini_Grand.indd 27
12.3.2015 11:00:24
15-0658_Navod_Gmini_Grand.indd 27
3.7.2015 10:26:50