2. Place rear axle into stroller frame. You should
hear snap. Ensure that the
brake is facing the rear.
Fig 2
3. Place the rear wheels into axle pins. When you adjusted properly you should hear
"click". Make this action for the second front whee
l too.
IMPORTANT:
Inflate tires of rear wheels max. 35 PSI (240 KPa)
/ (2.4 BAR), be
careful not to exceed the specified value.
Fig 3
4. Place the front swivel wheels into front housing
. When you adjusted properly
you should hear "click". Make this action for the second front wheel too.
WARNING:
Before using the stroller, make sure that the wheel
s are well
secured to the structure.
Fig 4
5. The stroller is equipped with front swivel/fixed
wheels.
It is suggested to use the fixed wheels on particul
arly uneven grounds. The wheels
in swivel mode instead, can be used to improve the stroller’s handling on regular
road surfaces.
To lock the front swivel wheels, press down the locking button on the front yoke. To
release the locking device of the front fixed wheel
s, press again the locking button
with your foot. Regardless of the position in which
the wheel is located, they will
lock in straight position.
Fig 5
WARNING:
Both wheels must always be locked or released to swivel at the same time.
WARNING:
Before using the stroller, make sure that the wheel
s are well secured to the structure.
ASSEMBLY OF THE SEAT: STROLLER CONFIGURATION
6. Put the seat into the corresponding holes on the
construction of a stroller, as
shown in Figure 6, you should hear a click fuses.
WARNING:
Make sure the seat is installed properly by pulling
it upward.
Fig 6
15-0229_Navod_Gmini_Grand.indd 22
12.3.2015 11:00:23
15-0658_Navod_Gmini_Grand.indd 22
3.7.2015 10:26:48