Stove safety device
“MASS TEMP” stove status
Blocked flue or flue gas outlet
Clean the flue and the outlet
Faulty electronic board
Replace the electronic board (use only
original spares)
Faulty limit temperature control sensor
Replace the control sensor (use only
original spares)
Badly positioned smoke sensor
Check that the sensor is correctly
positioned (see wiring diagram)
Incorrect parameter settings
Check parameter settings
a
This instruction booklet contains all the necessary information for installation, operation and maintenance.
Only call the Gruppo Piazzetta S.p.A. service centre after having scrupulously followed all the instructions.
Smoke sensor
“NO CONN” stove status
No connection between the 2-pin
terminal of the smoke sensor or the
ambient and the electronic board
Check correct insertion/position of the
connector (see wiring diagram)
Faulty electronic board
Replace the electronic board (use only
original spares)
Badly positioned smoke sensor
Check that the sensor is correctly
connected
Appliance runs for 9-10 minutes and
then goes out
Heat sensor locked
Repeat ignition procedure. If the
problem persists, contact an
authorised technician
Combustion gases have not reached
the required ignition temperature
Repeat ignition procedure. If the
problem persists, contact an
authorised technician
Heat sensor badly connected
Check the wiring and connections
Blocked flue
Clean flue system
Failed ignition
See “NO ACC”
Faulty electronic board
Replace the electronic board (use only
original spares)
Pellet-charging system blocked
Empty the pellet hopper; check and
clean the auger and chute
Problem
Cause
Solution
H07026300 / DT2000786 – 00
55
English
