PIAGGIO 2012 MSS APE 50, Service Station Manual

Page: 105 / 117

Specific tooling
AC/UNI Gun Gun for "Thio Bostik 80" cartridge
AC/UNI Whisk Whisk for "Thio Bostik 80" car-
tridge
- Once the adhesive sealing compound is applied, proceed to fit three finishing strips (trimmings) to the
sides of the frame, at the positions previously shown in the figure, and two profiles until they adhere to
the pane and the frame edge.
CAUTION
FIT THE THREE STRIPS WITH THE TOP EDGE FACING THE PANE. THEN APPLY THE BAND ON
THE LOWER TRIM, AND THE TAPE FROM THE BODYWORK ON THE SIDE STRIPS TO ENSURE
A PERFECT ADHERENCE, IN THE DRYING PHASE. ONCE DRIED (NEEDED TIME AT 20°: 4 TO
5 HOURS «DUST OUT» - THAT IS FOR THE INITIAL STAGE; 6 HOURS FOR TOTAL HARDENING),
REMOVE THE TOOL, BEING CAREFUL TO REMOVE WITH A SPATULA ANY ADHESIVE SEAL-
ING COMPOUND THAT MAY HAVE OOZED WHEN THE TRIMS WERE PRESSED.
Specific tooling
020114Y Pane positioning band
MSS APE 50
Chassis
CH - 105