-5-
PKI-0041-5-E
Hexagon head bolt
(Item ③ )
Installation bracket A
(Item ② )
（2）Combine the Installation bracket (Item ② ) and the
Hexagon head bolt (Item ③ ) as shown in the fi gure
below.
（3）Take 2 sets made up of the Hex nut and Slider
assembly that was combined in (1) put them into
the lamp main unit positions as indicated in the
fi gure. Be careful not to drop the Hex bolt out of
the Slider.
● If installing the lamp main units RF10 and
RF18 to the vehicles without combining them,
make sure to install 2 Installation brackets on 2
positions on the lamp main unit. With unit RF6 ,
one Installation bracket can be used in the center
but we recommend installing them on 2 positions.
Slider assembly
（4）Take 2 sets made up of the Hex nut and bracket
assembly that were combined in (2) and using the
Hexagon socket head bolt (M10/Item ⑥ ), screw it
fi rmly in place.
Hexagon socket
head bolt
(M10) (Item ⑥ )
Hexagonal wrench
(M10) (Item
㉘
)
Installation bracket A
(Item ② )
Tightening torque：18ft・Ibs (24N・m)
● After the lamps are installed on the
vehicle, the Hexagon socket head
bolts (M10/Item ⑥ ) can be loosed
and the angle of the lamp can be
adjusted.
Advice
10°
10°
Hexagon socket
head bolt
(M10) (Item ⑥ )
