5 Installation
P-63x Nanopositioner
PZ247E
Version: 1.1.0
21
Center of load at an unsuitable position:
Figure 6: Tall load and center of load too far above the platform
Figure 7: Unwanted lever effect and center of load on the side of the platform
Requirements
You have read and understood the general notes on installing (p. 15).
The P-63x is
not
connected to the electronics.
Tools and accessories
Screws of suitable size and length (p. 35)
Suitable screwdriver
Fixing the load
1.
Align the load on the P-63x so that the mounting holes in the load and the holes in the
platform are in line.
2.
Hold the load so that it cannot move while tightening the screws.
3.
Fix the load by tightening the screws in the mounting holes (p. 35) provided. Pay
attention to the torque range (p. 36) specified for the screws, and avoid torques
>0.5 Nm on the motion platform.
4.
Check that the load is sitting firmly on the motion platform.
