5 Installation
24
Version: 1.1.1
PZ245E
P-2x5 Piezo Actuator
Tools and accessories
M8 screw of suitable length; see "Dimensions" (p. 45)
Open-end wrench AF 27
Suitable screwdriver
Mounting the P-2x5
1.
Use an SW 27 open-end wrench to hold the base of the P-2x5.
2.
Attach the P-2x5 to a suitable surface with an M8 screw. For this purpose, use the M8
mounting hole on the bottom of the base; see "Dimensions" (p. 45).
3.
Remove the open-end wrench from the base.
5.4
Optional: Mounting a Tip
INFORMATION
Different mechanical connections to a load are made possible by optionally available flat or ball
tips (p. 13).
Requirements
You have read and understood the general notes on installing (p. 19).
The P-2x5 is
not
connected to the electronics.
The P-2x5 is discharged (p. 34) and short-circuited by the shorting plug (p. 12) provided.
Tools and accessories
Optionally available flat or ball tip (p. 13)
Open-end wrench for holding the tip of the P-2x5 (p. 10) in place:
−
P-225: AF 13
−
P-235: AF 17
Mounting a flat or ball tip
1.
Use an open-end wrench with a matching jaw size to hold the tip of the P-2x5 in place.
2.
Screw the flat or ball tip into the mounting hole of the P-2x5 by hand.
3.
Remove the open-end wrench from the tip.