8
“
A
SSEMBLE
I
NSTRUCTIONS
”
S
TEP
4 –
Rear Stabilizer Assembly
a. Attach the
Rear Stabilizer (4)
to the
Rear
Support Frame (2).
b. Fully secure
two
Lock Washers (M8)(92)
, two
Washers (8x16x2.0t)(94)
and two
Bolts, Socket Head
(M8xp1.25x90mm)(126)
that attach to the
Rear Stabilizer (4)
to the
Rear
Support Frame (2).
S
TEP
5 –
Rear & Main Frame Assembly
a. Thread the
Leveler (35)
tightly into the
Rear Support Frame (2).
To make the Leveler (35) rest firmly on the floor, please review page 13 on the manual.
b. Connect the
Pulse Sensor Wire 3 (145)
to the
Pulse Sensor Wire 2 (144). Be careful not to pinch the wires.
NOTE:
Four
Nylock Nut (M8xp1.25)(136)
will be pre-attached on the front of the
Rear
Support Frame Assembly (2)
c. Remove four
Nylock Nut (M8xp1.25)(136)
from the front of the
Rear
Support Frame Assembly (2)
d. Attach the
Rear Support Frame Assembly (2)
to the
Main Frame (1)
by securing four
Nylock Nut
(M8xp1.25)(136). Be careful not to pinch the wires
e. Attach the
Connection Cover (33)
to the
Main Frame (1)
by securing
Screw, Round Head
(M5xp0.8x40mm) (108).
**Make sure the above parts are tightened before moving on to the next page**
NOTE:
“Small Tip:
Attach screws and bolts to the assembly parts first before secure
”
**Please do not secure the bolts unless you make sure Bolts all go into screw holes of Rear Stabilizer and
Rear Support Frame**
Be sure to thread the
Leveler (35) tightly into the
Rear Support Frame (2)
before moving to the next
page
USE HARDWARE KIT
A
NOTE:
After connecting the wires
’ pins, slightly and gently pull two sides of wires to test and
make sure whether the wires are fully connected.
Summary of Contents for XT-800
Page 21: ...21 PRODUCT PARTS DRAWING A...
Page 22: ...22 PRODUCT PARTS DRAWING B...
Page 26: ...26...