Physio Control LIFEPAK 15, Service Manual

Page: 316 / 527

LIFEPAK 15 Monitor/Defibrillator
Service Manual
Replacement Procedures
Rear Case Replacement
Section Menu Section Contents Procedures Back Index
318
8
Installing the Rear Case

To install the rear case: 23 steps, (Page 1 of 3)
•
When replacing the Rear Case, use Rear Case Repair Kit (MIN 3305431-024) (p. 512) .
•
Clean adhesive areas with alcohol.
Transfer the following parts from the old rear case to the new rear case:
1. Install handle ( 3207706-000 ), handle covers and shoulder straps as described in Handle Replacement (p. 321) .
NOTE:
If a new handle is required, use Handle Repair Kit (MIN 3305431-020) (p. 509) .
2. Install the drain seal ( 3006291-00 ) into the rear case.
3. Install the CO2 exhaust tubing ( 3012140-002 ) onto rear case (if CO2 option).
4. Install the contact PCB as described in Installing the Contact PCB (A07) (p. 359) .
5. Install the system connector and auxiliary connector cables as described in Installing the System Connector Cable (W08) or
Auxiliary Power Cable (W09) (p. 333) using new O-ring seals ( 200060-011 ).
6. Install the EMI shield ( 3206960-002 ) as described in EMI Shield Replacement (p. 305) (new part from repair kit).
7. Install the battery pins/power PCB cable (W10) ( 3207692-000 ) as described in Installing the Battery Pins/Power PCB Cable
(W10) (p. 336) .
8. Install the power to contact PCB cable (W05) ( 3207261-001 ) to J42 of the contact PCB.
9. Install the USB flex assembly as described in USB Flex Module (W14) Replacement (p. 338) .