8
PHYLINK Covert Network Camera Quick Install Guide
Hardware Installation
3.2 Main Unit Installation
The Sensor Unit and Main Unit are connected by an 8 meter cable, providing flexibility
to place the Sensor Unit in one place and the Main Unit elsewhere.
Insert the RJ11 Plug into the RJ11 Jack on Main Unit.
IMPORTANT!
The RJ11 Plug must be insert
into RJ11 Jack before the
Main Unit is powered on.
Connect the sensor unit to the main unit
Connect the Main Unit to your router or switch using the network cable.
Using the included power adaptor, plug one end into the Power Connector and plug
the other end into a power outlet.
DC12V
LAN
Reset
I/O
Main Unit Panel
DC Power Cable
Network Cable
Router
Note: The DHCP sever and UPnP must be enabled on your router (which is default
setting on most router) to assign a local IP address to the network camera.
If needed, please refer to your router's user manual on how to enable DHCP server
and UPnP.
Connect Network and Power
