FASTCAM-PCI Series Hardware Manual
2.2.4. Connectors Specifications
The FASTCAM-PCI supports the following input and output signals.
+
1. OUT1
2. OUT2
3. T- TTL
4. T- SW
1 EXTOUT1 Output connector
A BNC connector for an output signal that specifies the first frame when a non-sync reset trigger
signal is used.
2 EXTOUT2 Output connector
A BNC connector for an output vertical sync signal for sync operation with strobe and/or pulsed
laser units.
3 TRIGGER TTL IN Input connector
A BNC connector for TTL compatible signal that controls start and end of recording in a selected
recording mode. The input signal is +5 volt positive and the pulse width should be over 50
microseconds.
4 TRIGGER SW IN Input connector
Switch contact between the shield and the center conductors of the BNC connector controls start
and end of a recording in a selected recording mode.
- 12 -
