5
POWERPOD 1460
English
Deutsch Español Français
Português
日本語
简体中文
26. Pan/Balance Control
This alternates the degree or level of audio that the left
and right side of the main mix should receive. On mono
channels, this control will adjust the level that the left and
right should receive (PAN), whereas on a stereo channel,
adjusting the BAL control will attenuate the left or right
audio signals accordingly.
27. Peak Indicator
This LED indicator will illuminate when the device hits
high peaks, slightly before overload occurs. It is best to
adjust the gain of the channel to a level slightly below the
point that the peak indicator will light up. This ensures
greater dynamic range in your audio.
28. PFL button and Indicator
The PFL - or Pre-Fader Listen - button is pushed to allow
the signal of a corresponding channel to be sent to the
Control Room/Phones control (pre-fader, post-EQ), for
use with either headphones or studio monitors. This
allows easier setting of the input gain and tracking of
audio by sound engineers. The corresponding green LED
will illuminate when that channel’s PFL is activated.
29. Channel Fader
This control will alter the signal level that is sent from the
corresponding channel to the main mixing bus.
DSP Effect Processor
30. Digital Effect Display
This 2-digit numeric display shows the program number
that is currently applied to your EFX audio signal. When
you rotate the Program control, you can scroll through
different program numbers; however the display will
revert back to the original program if a new program is
not selected within a few seconds. For a list of available
effects, please observe the Digital Effect Table.
31. Sig and Clip Indicators
Located within the Digital Effect Display are Clip and
Sig LEDs. The Sig LED will light up when any signal is
received by the effect processor, and the Clip LED will
light up shortly before excessive signals are dynamically
clipped. If the Clip LED lights up too often, it may be
advisable to turn down one or all EFX controls on input
channels to ensure the signal level is not too high.
32. Program Control
This control is used to scroll through the various effects.
Turning the control clockwise will allow users to ascend
into higher program numbers, and turning it counter-
clockwise will allow users to descend into lower program
numbers. Pushing this control will apply the new effect.
When a tap-delay effect is selected, pressing this control
will allow users to select the tap-delay time.
By pushing the button several times, the effect processor
interprets the time between last two pushes and
remembers this as the delay time, until the button is
pushed again (this is kept, even after the power is turned
off). When the tap delay effect is selected, a small LED
will flash within the digital effect display window at the
selected intervals.
33. DSP Level Fader
This control allows users to adjust the final signal sent
from the built-in digital effect processor, the signal of
which is sent to the main left and right mixing bus.
