Phonic POWERPOD 1060, User Manual

Page: 8 / 27

page 7
PHONIC CORPORATION POWERPOD User's Manual
9. Monitor Outputs
These 1/4" TS outputs are the fi nal output from the
Monitor send mixing bus. This feed may be used to
connect to an amplifi er and speaker. Feeding the output
from the Monitor out to an amplifi er (and possibly an
equalizer) and then to a fl oor monitor speaker allows
artists to monitor their own instruments or vocals whilst
performing, or an engineer to monitor the mix.
10. Main Outputs
These jacks will output the fi nal stereo line level signal
sent from the main mixing bus. The primary purpose of
these jacks is to send the Main output to external devices
that may run in parallel with the mixer. This may include
additional power amplifi ers, mixers, PA systems, as well
as a wide range of other possible signal processors.
The Powerpods 620 and 740 Deluxe both feature a
monaural main outputs, where the Powerpods 1060 and
1062 both feature stereo main output jacks.
11. Power Amp Inputs
(Powerpods 1060 and 1062 Deluxe Only)
These inputs support 1/4" TS plugs and can be used for
the inclusion of an external line level stereo signals to
the built-in power amplifi er. If a device is connected to
the power amp inputs, the main feed will automatically
bypass the power amp and the inserted feed will be
amplifi ed and sent to the Speaker Outputs instead.
6. AUX Inputs
These TS inputs (which are mono inputs on the
Powerpods 620 and 740 Deluxe, stereo inputs on the
Powerpods 1060 and 1062 Deluxe) connect the mixer
with parallel external devices, such as sub mixers or
external effect processors, receiving the processed
signal from another source and feeding it to the AUX
mixing buses. The stereo AUX inputs (featured on the
Powerpods 1060 and 1062 Deluxe only) can be used
as monaural inputs by simply plugging the device’s 1/4"
phone jack into the left (mono) stereo input and leave the
right input bare. Your good friend, Jack Normalizing, will
take care of the rest.
7. Foot Switch Jacks
These ports are for the inclusion of a non-latch foot
switch, used to remotely adjust properties of the built-in
Digital Effect processor. The Powerpods 620 and 740
Deluxe feature a single foot switch jack, which allows the
user to remotely turn on and off the digital effects. The
Powerpods 1060 and 1062 Deluxe, on the other hand,
feature 2 foot switch jacks, the lower of which jack is
used to adjust the tap delay properties, and the upper is
used for the turning digital effects on and off.
8. EFX (Effect) Outputs
These 1/4" TS outputs are the fi nal output from the EFX
send mixing bus. This feed may be used to connect to an
external digital effect processor, or even to an amplifi er
and speakers, depending on your desired settings.