Phonic MX 300, User Manual

Page: 7 / 22

7 MX 300 / 306
BACK PANEL DESCRIPTION
23. AC Connection
Used to plug the power cord in.
24. AC Voltage Selector
Make sure that the selector is properly set according
to your current local power supply company.
25. Fuse Holder
Only operate the fuse when the device is disconnected
from mains. Only use fuses of the same rating and
power.
26. Master Output
Master output connects to the main amplifier (DJ final
mix after crossfader section), accepts RCA jacks.
27. Booth Output
Connect your monitor system here.
28. REC OUT Output
To connect your recording unit. These jacks are
RCA types, which are suitable for connection of a
recording device. Its level is not influenced by the
master control.
29. Phono / Line Inputs Sockets
These inputs, for ch-1~3, accept RCA-plug connectors.
Use phono input socket for phonograph turntables.
Use line socket for CD players, cassette players.
Line level musical instruments with stereo outputs
such as rhythm machines or samplers should also
be connected with the line input socket.
30. MIC Sockets
Connect your microphone with 1/4” jack plug here.
The signals of Mic 3 can be controlled via ch-3, if
phono 3/line 3/mic 3 switch is set to mic 3. The signals
of Mic 2 can be controlled via ch-2, if phono 2/line
2/mic 2 switch is set to mic 2.
31. GND
Connect the earth cable from the turntables. This
helps to reduce humming and pop noise.
REPLACING THE CROSSFADER
First, remove the fader knob, and then remove the two outer screws on the fader panel. Take the fader out,
unplug the connection cable, and connect the new fader by fixing it in the device.